Kit Assembly - Metra 99-6525 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Attach the metal clips provided with
this kit to the top and the plastic clips
provided to the bottom of the radio trim
panel. (Figure A)
2. Attach the lower support bracket to the
radio trim panel with climate controls.
(Figure A)
3. Attach the radio brackets to the pocket
using the (2) #8 x 3/8" Phillips pan-head
screws provided with this kit towards
the front of the pocket, and the (2) #8 x
1/2" Phillips flat-head screws provided
towards the back. (Figure B)
Note: If the screws are not attached this
way, the assembly will not slide into
the dash.

KIT ASSEMBLY

Metal clips
Plastic clip
Plastic clip
(Figure A)
4. Remove the metal "DIN" sleeve and trim
ring from the aftermarket radio.
5. Slide the radio into the pocket/bracket
assembly, and then secure using the screws
supplied with the radio. (Figure C)
Continue to Axxess Interface Installation
Use countersunk screws
for the rear mounts on
the pocket
(Figure B)
(Figure C)
REV. 4/19/22 INST99-6525
3