Timer Operation - Easy Home EPA080BAUW Manual Del Usuario

Operation
Control panel instructions
Cool
Fan
Dry
Power button: Press to turn the unit on or off.
LED Display:
- While on COOL mode shows the set temperature in °C
or °F
- When on FAN and DRY mode shows the room tem-
perature
- Displays error codes
AUTO mode
- Can only be activated by remote control
- There is no AUTO mode display on the control panel
- Display will show COOL or FAN based on ambient
room temperature
SLEEP mode
- Can only be activated from the remote control
- Conserves energy during sleeping hours
- Once activated, SLEEP mode will increase the set tem-
perature by 1 degree for 30 minutes. The set temperature
will increase another degree in the next 30 minutes and
then will maintain temperature for 7 hours before return-
ing to the original setting.
- The SLEEP function is only available in COOL mode
16
POWER

Timer operation

Note: Timer function can only be activated by the remote
control.
This unit has two timer related functions:
- Timer on: sets the amount of time after which the unit
will turn on
- Timer off: sets the amount of time after which the unit
will turn off
Timer on function:
- Press the Timer On button on the remote control
- The last time period that was set will show on the display
- Press the Timer On button repeatedly to set the amount
of hours that should pass before the unit turns on
- Wait two seconds for the programming to be accepted
by the unit
Timer off function:
- Press the Timer Off button on the remote control
- The last time period that was set will show on the display
- Press the Timer Off button repeatedly to set the amount
of hours that should pass before the unit turns off
- Wait two seconds for the programming to be accepted
by the unit
Notes:
- Pressing the Timer On or Timer Off buttons will increase
the set time in 0.5 hour increments up to 10 hours and
then in 1 hour increments up to 24 hours
- The display will revert back to showing the previous tem-
perature setting if the unit does not receive a signal within
a 5 second period during programming
- Adjusting the timer setting to 0.0 hours will cancel the
Auto-timer settings
Operation
17