Battery Replacement - Greenlee CMGL-10 Manual De Instrucciones

Specifications
Display: 3-3/4-digit LCD (3999 maximum reading) and a 40-segment bar graph
Polarity: Automatic
Sampling Rate: 2 per second (numeric)
20 per second (graph)
Auto Power Off: After 30 minutes of inactiviity
To disable this feature, pressing HOLD while turning the unit on.
Over Range Indication: Leftmost digit flashes
Jaw Opening: 30 mm (1.18")
Overvoltage Category: Category II, 600 Volts; Category III, 300 Volts
Operating Conditions: -10 °C to 50 °C (14 °F to 122 °F), 0% to 85% relative humidity
(non-condensing)
Storage Conditions: -20 °C to 60 °C (-4 °F to 140° F), 0% to 75% relative humidity
(non-condensing)
Remove battery
Battery: Two AA 1.5-Volt Batteries (NEDA 15A or IEC LR6)

Battery Replacement

Before opening the case, remove the leads or jaw from the circuit and shut off the unit.
Failure to observe these warnings can result in severe injury or death.
1. Disconnect the unit from the circuit. Turn the unit OFF.
2. Remove the screw from the battery compartment cover.
3. Remove the battery compartment cover.
4. Replace the batteries (observe polarity).
5. Replace the cover and screw.
14