EMAK Oleo-Mac APACHE 92 Manual De Uso Y Mantenimiento página 28

(14) TRAVEL DIRECTION LEVER
It controls the power supplied to the rear wheels and regulates the speed of the mower in both directions.
In the basic setting it is equipped with a mechanical cruise control function, which is automatically
deactivated by pressing the brake pedal.
Changing the travel direction from forward to reverse or from reverse to forward
is only possible after stopping the mower. When the brake pedal is stepped on, the
travel lever automatically shifts to position "N".
(15) CHOKE
Enables the starting of a cold engine.
(16) BY-PASS LEVER – FREE MOVEMENT OF THE REAR WHEELS
The bypass lever serves to disengage the transmission for the rear wheel drive and is used to push or
pull the mower without using the engine. The lever is located on the rear side of the mower and has the
following two positions:
ATTENTION! On the 92 EVO 4x4 mower the lever is used primarily for bleeding the
hydrostatic system. Due to the high demands on equipment, have this procedure performed
by a specialised service centre.
The mower must not be used (gear shifted into drive) if the by-pass lever is in the disengaged
position - there is a danger of damage to the transmissions!
Moving the lever closer to the letter F corresponds to
Forward
F
drive a higher speed and vice versa
N
Neutral The mower is still
Moving the lever closer to the letter R corresponds to
Reverse
R
drive a higher speed and vice versa
CHOKE
Position Rear wheel drive
(0) DISENGAGED
(1)
Starting a cold engine
Lever is extended - for pushing the
mower
Lever is inserted - for driving the
ENGAGED
mower
28
Use