VONROC S4 LM505DC Traducción Del Manual Original página 15

• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the CD802AA charger
(Fig. K)
1. Take the battery (23) from the machine.
2. Turn the battery (23) to upside down position and
slide it onto the charger (26) as shown in Fig. K.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(27) will lighten up and show the charger status.
The charger has 2 LED indicators (27) which indicate
the status of the charging process:
Red LED Green LED
Status status
Off Off
Off On
On Off
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charg-
er plug from the outlet and remove the battery from
the charger.
When the machine is not being used over
a longer period of time it is best to store the
battery in charged condition.
Charging the battery with the CD820AA dual
charger (Fig. L)
1. Take the battery (26) from the machine.
2. Turn the battery (26) to upside down position
and slide it onto the charger (30) as shown in
Fig. L.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on the
charger (31, 32, 33) will lighten up and show
the charger status.
WWW.VONROC.COM
Charger status
No power
Standby mode:
- No battery is inserted or,
- Battery inserted but
charging has finished
Battery charging in progress
The charger has 6 LED indicators (31, 32, 33)
which indicate the status of the charging process:
Item Conditions
Stand by Power on
Charging Started charging
(10-19V DC±0.5V DC)
Halfway charging
(19-20V DC±0.5V DC)
Finished charging
(20-21V DC±0.5V DC)
Fully Trickle charging
charged ≤300±150mA
Stop charging
High tem- High-temperature
perature protection of the
battery works
• Fully charging the 4Ah battery may take up to
85 minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from the
charger.
When the machine is not being used over
a longer period of time it is best to store the
battery in charged condition.
Assembling the lower handle (Fig. A, B)
1. Mount the lower handle (14) onto the lawn
mower body, as shown on figure B.
2. Put the washer (34C) onto the bolt (34B).
3. Screw the handle adjustment knob (34A) onto
the bolt (34B) with assembled washer and
secure the handle by closing it.
4. Repeat these steps for the other side.
Assembling the upper handle (Fig. A, C, D)
1. Attach the upper handle (1) to the lower handle
(14).
2. Secure the upper handle (1) by inserting the
bolts (15B), washers (15C) and handle knobs
(15A) as shown on figure C.
3. Fixate the cable to the handle by using the
cable holders (6), as shown on figure D.
EN
LED colour
Red Amber Green
On On On
Blink Off Off
On Blink Off
On On Blink
On On On
On On On
15