VONROC S4 LM505DC Traducción Del Manual Original página 16

EN
Assembling and mounting the grass box
(Fig. A, E, F, G, H)
The lawn mower shall not be operated
without either the entire grass catcher or
the guard in place.
It is possible to use the lawn mower with or without
grass box. Remember though that when cutting
without the grass box, the grass box lid (11) must
be lowered. Do not operate the mower with outlet
lid lifted.
1. Mount the Grass box carrying handle (16) onto
the grass box cover (12), as shown on figure E.
2. Mount the grass box cover (12) onto the grass
box bag (10), as shown on figure F.
3. Ensure the notches are properly inserted until
a clicking noise can be heard, as shown on figure
G.
4. Lift the grass box lid (11) and attach the assem-
bled grass box onto the lawn mower, as shown on
figure H. Ensure the indents in the grass box align
properly with the holders of the lawn mower body.
Note: the grass box is fitted with a grass level
indicator (13), which shows the amount of mowed
grass. As long as the grass box is not full, the indi-
cator will be opened. When the grass box is full, the
indicator will close. In that case immediately stop
mowing and empty the grass box. This indicator is
only a rough guideline, of which the functionality
depends on the condition inside the grass basket.
Replacing the cutting blade (Fig. A, M)
Before any work on the power tool, remove
the battery.
When replacing the cutting blade, wear
protective gloves. Danger of injury when
touching the cutting blade.
Only use blades that are recommended by
the manufacturer.
1. Remove the grass box.
2. Turn the mower onto its side.
3. Firmly hold cutting blade using protective gloves.
4. Turn the cutting blade fixing screw counterclock-
wise to loosen it, as shown on figure M.
5. Replace or sharpen the cutting blade.
6. Install the cutting blade, use the above pro-
16
cedure in reversed order (holes in the cutting
blade must be seated on the spindle pins).
7. It is best to entrust sharpening or replacement
of cutting blade to a qualified person. Only orig-
inal parts should be used. All defects should be
repaired by service workshop authorized by the
manufacturer.
4. OPERATION
Before using, always visually inspect to see
that the blades, blade bolts and cutter
assembly are not worn or damaged. Please
remove the battery from the tool. Replace
worn or damaged blades and bolts in sets
to preserve balance.
If the machine starts to vibrate abnormally
(check immediately):
- inspect for damage,
- replace or repair any damaged parts,
- check for and tighten any loose parts.
Immediately switch off the machine in the
following cases:
- whenever you leave the machine,
- before clearing blockages or unclogging
chute,
- before checking, cleaning or working on
the machine,
- after striking a foreign object. Inspect the
machine for damage and make repairs
before restarting and operating the ma-
chine;
Be careful during adjustment of the
machine to prevent entrapment of the
fingers between moving blades and fixed
parts of the machine.
Adjusting the cutting height (Fig. A, I)
Switch off the equipment, wait for the blade
to stop and remove the battery. There is
a risk of injury.
Depending on the preferred cutting height, you
can adjust the heigh level in one of five positions.
Adjust the cutting height according to the needs of
your lawn. The cutting height depends on the kind
of lawn and its actual height. When mowing high
grass, start with the maximum cutting height and
WWW.VONROC.COM