Code Setting - Dogtra 4500 EDGE Manual De Instrucciones

11. CODE SETTING

To set the coding for the Dogtra 4500 EDGE transmitter to an existing
receiver/collar, or an Additional receiver/collar, follow the steps below.
*Attention: Turn the mode selection dial to "P", or "L", to check that
54
unit has been coded properly.
1. Start by turning on the transmitter
by holding down the on/off button
on the back of the transmitter.
2. Set the transmitter's intensity dial
to "0", and the mode selection dial
to "C".
3. In the off position hold down the
receiver/collar on/off button until
the green LED indicator light
begins to blink rapidly.
4. Immediately press the button on
the transmitter of the color you
would like the receiver/collar to be
coded to.