How To Change The Battery - Dogtra 4500 EDGE Manual De Instrucciones

15. HOW TO CHANGE THE BATTERY

The Dogtra 4500 EDGE batteries are user replaceable.
To replace the battery in the transmitter, follow the instructions below.
1. Begin with the transmitter turned off.
2. Unscrew the two Phillips head screws attached to the back of the belt
clip and remove the belt clip. – (1)
the screws.
3. Unscrew the two screws on the back of the transmitter. – (2)
the screws.
4. Holding the battery wire, detach the wire from the battery connector
plug(see picture).
5. Holding the battery wire of the new battery, plug the wire in to the
battery connector plug.
* Attention
the connector.
The battery wires must be inside the battery compartment tucked
neatly along the right side of the battery.
58
(1)
(2)