Connecting To A Power Source - Louisiana Grills BLACK LABEL LG300BL Guía De Montaje

A
8
B
8 3
4
9
1
2
10
INSTALLING THE FLAME BROILER COMPONENTS
PARTS REQUIRED:
1 x
1 x
4
INSTALLATION:
NOTE: THE FLAME BROILER COMPONENTS MAY BE LIGHTLY COATED WITH OIL
TO AVOID RUSTING WHEN SHIPPED.
• Insert the Flame Broiler Main Plate into the Main Grill Body, left side first. Rest
the Flame Broiler Main Plate slot onto the ledge tab on the left side, then rest
the right side on the built-in ledge (on the inside right) of the Main Grill Body
that directs grease towards the Grease Tray. It will sit slightly at a downward
angle. Note illustration 8A.
IMPORTANT: IF THE MAIN PLATE IS RESTING ON THE BASE OF THE MAIN GRILL
BODY, IT IS INSTALLED INCORRECTLY. THE FLAME BROILER MAIN PLATE IS USED
TO DISTRIBUTE THE HEAT EVENLY. POOR INSTALLATION OF THIS PART MAY
RESULT IN DAMAGE TO YOUR MAIN GRILL BODY.
• Place the Flame Broiler Slider on top of the Flame Broiler Main Plate, covering
the slotted openings. Ensure the raised tab is on the left, to easily adjust for
direct or indirect flame when cooking. Note illustration 8B.
NOTE: WHEN THE FLAME BROILER SLIDER IS OPEN, AND DIRECT FLAME IS USED
WHILE COOKING, DO NOT LEAVE THE GRILL UNATTENDED FOR ANY PERIOD OF TIME.
PLACING THE COOKING COMPONENTS
PARTS REQUIRED:
1 x
1 x
INSTALLATION:
• Place the Cooking Grid on the grid ledge inside the Main Grill Body.
• Position the Upper Cooking Rack onto the Cooking Grid. The Upper Cooking
Rack can be placed as desired.
NOTE: TO MAINTAIN THE SEARING AND GRILLING PERFORMANCE OF YOUR
COOKING GRIDS, REGULAR CARE AND MAINTENANCE IS REQUIRED.

CONNECTING TO A POWER SOURCE

STANDARD OUTLET
This unit requires 110-120 Volt, 60 Hz, 220 Watt. It must be a 3-prong grounded plug.
Ensure grounded end is not broken off. The control uses a 110-120 volt, fast-blow
fuse to protect the board from the igniter.
GFCI OUTLETS
This unit works on most GFCI outlets, with a recommended size of 15 amp service.
If the GFCI outlet is highly sensitive to power surges, it will likely trip during the
start-up phase of operation. During the start-up phase, the igniter draws 200-700
watts of electricity which can be too much power for a GFCI outlet to handle. Each
time the GFCI trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
Disconnect the igniter from the main wiring harness. Use the manual start-up
procedure. The Louisiana Grills® unit can operate using a 12 volt, 100 watt positive
wave length inverter plugged into your automobile outlet. To use the automatic igniter,
it is recommended to use a minimum of a 1000 watt positive wave length inverter.
IMPORTANT: DISCONNECT UNIT FROM POWER SOURCE WHEN NOT IN USE.
Flame Broiler Slider (#3)
Flame Broiler Main Plate (#4)
Upper Cooking Rack (#1)
Cooking Grid (#2)
www.louisiana-grills.com
5