Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
10
2
3
3
11
9
12
INSTALLING THE COOKING COMPONENTS
PARTS REQUIRED:
1
x
Upper Cooking Rack (#1)
1
x
Cooking Grid A (#2)
2
x
Cooking Grid B (#3)
INSTALLATION:
•
Place the Cooking Grids A and B side-by-side on the lower grid ledges inside
the Main Grill. Order is not particular.
•
Following, place the Upper Cooking Rack on the upper ledge inside the Main
Grill. The Upper Cooking Rack will lock into place.
IMPORTANT: TO MAINTAIN OPTIMAL SEARING AND GRILLING PERFORMANCE
OF YOUR COOKING GRIDS, REGULAR CARE AND MAINTENANCE IS REQUIRED.
PLACING THE GREASE BUCKET
PARTS REQUIRED:
1
x
Grease Bucket (#9)
INSTALLATION:
•
Place the grease bucket on the spout hook on the bottom of the main barrel.
Ensure it is level to avoid grease spills.
•
The unit is now completely assembled.
CONNECTING TO A POWER SOURCE
STANDARD OUTLET
This unit requires 110-120 Volt, 60 Hz, 375 Watt. It must be a 3-prong grounded plug.
Ensure grounded end is not broken off. The control uses a 5 amp, 110-120 volt, fast-
blow fuse to protect the board from the igniter.
GFCI OUTLETS
This unit works on most GFCI outlets, with a recommended size of 15 amp service.
If the GFCI outlet is highly sensitive to power surges, it will likely trip during the
start-up phase of operation. During the start-up phase, the igniter draws 300-700
watts of electricity which can be too much power for a GFCI outlet to handle. Each
time the GFCI trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
Disconnect the igniter from the main wiring harness. Use the manual start-up
procedure. The unit can operate using a 12 volt, 100 watt positive wave length
inverter plugged into your automobile outlet. To use the automatic igniter, it is
recommended to use a minimum of a 1000 watt positive wave length inverter.
IMPORTANT: DISCONNECT UNIT FROM POWER SOURCE WHEN NOT IN USE.
www.louisiana-grills.com
7
Publicidad
Tabla de contenido
