Using The Usb/Sd Input; Bt Mode - auna Karaboom 100 Manual De Instrucciones

USING THE USB/SD INPUT

1. Plug your USB flash drive or SD card to the USB socket or SD slot
2. Press SOURCE button to select USB or SD mode, the unit can play
automatically. If not, press
3. Press the / to select track
4. Press the VOL+/VOL – to adjust the volume
Remarks: USB/SD port is easy to sensitive equipment, will cause the
equipment work is not stable
USB charging
There is a USB charger on the top of the unit to charge small devices such as
smartphones that can be charged via USB
Output power: 5V/2.1A max

BT MODE

1. Press the SOURCE button on the device or PAIR on the remote control
to select BT mode.
2. Then press the PAIR button on the remote control.
3. Turn on BT functionality on your BT device. Typically, BT controls are
found on the device's tools or setting menu (see your user manual).
4. Turn on BT connectivity and make your device 'discoverable". Choose
'add a new BT device' or 'setup BT device' on your device. It will start
to search. Once "Karaboom 100" shows on your device, select it. If your
device prompts you for a pass code, please enter 0000. If the pairing
attempt fails or times out, please start pairing procedure again (see
steps above).
5. After your device and the tower speaker have connected each other, a
sound can be heard.
6. Make sure the BT connection between the unit and the device is active.
7. Press the Play/Pause button to pause playback, press again to resume
playback and press button to skip forward to next track and to skip
backward to previous track.
EN
23