Descargar Imprimir esta página

Bosch sensixx B35L Instrucciones De Uso página 15

Ocultar thumbs Ver también para sensixx B35L:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
All manuals and user guides at all-guides.com
Rinsing the iron steam chamber (G)
Caution! Risk of burns!
This procedure helps to remove scale particles out of
the steam chamber.
Carry it out approximately every 2 weeks, if the water
in your area is very hard.
a) Ensure that the iron is cooled down.
b) Set the temperature selector (14) of the iron to the
"min" position.
Trouble shooting
Problem
The steam
• There is a connection problem.
generator does not
come on.
• The main power button is not switched on.
The iron does not
• The main power button is not switched on.
heat up.
• The temperature control knob is set to the
"min" position.
The iron begins
• During first use: Certain components on
to smoke when
the appliance have been lightly greased at
switched on.
the factory and may produce a little smoke
when initially heated.
• During later use: the soleplate may be
soiled.
Water flows through
• The steam function is being used before it
the holes on the
has reached temperature.
sole plate.
• The water is condensing inside the pipes
because steam is being used for the first
time or has not been used for a long time.
Dirt comes out
• There is a build-up of scale or minerals in
through the sole
the steam tank.
plate.
• Chemical products or additives have been
used.
The iron does not
• The boiler is not switched on or the water
produce any steam.
tank is empty.
• The water tank is not fitted onto the
housing correctly.
• The steam regulator is set to the minimum
position.
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main power
switch (12) to the "I" position.
e) Wait until the "steam ready" indicator lamp (9) ligh
up.
f) If the steam station has steam regulator (10), set it to
the maximum position
g) Hold the iron over the sink or a container to collect
the water.
Possible causes
• Check the mains cable, the plug and
the socket.
• Set the main power button (8) to the "I"
position.
• Set the main power button (8) to the "I"
position.
• Set the temperature control knob (13)
to the desired position.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing
at low temperatures (Variable steam
control (5)).
• Point the iron away from the ironing
area and press the steam release
button (15) until steam is produced.
• Use tap water mixed 50% with dis tilled
or demineralised water. If the tap water
in your district is very hard, mix tap
water with distilled water 1:2.
• Clean the sole plate with a damp cloth.
• Never add products to the boiler
water.
• Set the main power button (8) to the "I"
position and/or fill the water tank.
• Fit the water tank back onto the hou-
sing correctly (you will hear a click).
• Increase the steam flow by turning the
steam control (5).
en
.
Solution
15

Publicidad

loading