Operating; Starting A Cut; Breaking; When Taking A Break - Chicago Pneumatic CP 0016 Manual De Instrucciones

Safety and operating instructions
The CP 4132 and CP 4134 are equipped to with
inside trigger.
Start the machine by pulling inside trigger to
◆
upward position
◆ Stop the machine by releasing the inside
trigger.

Operating

Starting a cut

Stand in a stable position with your feet well
◆
away from the inserted tool.
◆ Press the machine against the working surface
before you start.
Start collaring at such a distance from the edge
◆
that the machine is capable of breaking the
material without leverage.
◆ Never try to break off too large pieces. Adjust
the breaking distance (A) so that the inserted
tool does not get stuck.

Breaking

◆ Let the machine do the work; do not press too
hard.
Avoid working in extremely hard materials for
◆
example granite and reinforcing iron (re-bar)
which would cause substantial vibrations.
◆ Any form of idling, operating without working
tool or operating with an uplifted machine must
be avoided.
18
All manuals and user guides at all-guides.com
A
CP 0016, 4130, 4131, 4132, 4134
◆ When the machine is lifted, the start and stop
device must not be activated.
Check regularly that the machine is well
◆
lubricated.

When taking a break

During all breaks you must place the machine
◆
in such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
◆ In the event of a longer break or when leaving
the workplace: Switch off the power supply and
then bleed the machine by activating the start
and stop device.

Maintenance

Regular maintenance is a basic requirement for
the continued safe and efficient use of the
machine. Follow the maintenance instructions
carefully.
Before starting maintenance on the machine,
◆
clean it in order to avoid exposure to hazardous
substances. See "Dust and fume hazard".
Use only authorised parts. Any damage or
◆
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
When cleaning mechanical parts with solvent,
◆
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
◆ For major service of the machine, contact the
nearest authorised workshop.
After each service, check that the machine's
◆
vibration level is normal. If not, contact the
nearest authorised workshop.

Every day

Before undertaking any maintenance or changing
the working tool on pneumatic machines, always
switch off the air supply and bleed the machine by
depressing the start and stop device then
disconnect the air hose from the machine.
◆ Clean and inspect the machine and its functions
each day before the work commences.
Check the tool retainer for wear and function.
◆
◆ Conduct a general inspection for leaks and
damage.
Check that the air inlet nipple is tightened and
◆
that the claw coupling is free from damage.
9800 0616 71 | Original instructions