Periodic Maintenance; Tightening Torques; Troubleshooting; Storage - Chicago Pneumatic CP 0016 Manual De Instrucciones

CP 0016, 4130, 4131, 4132, 4134
◆ For the machine to maintain the specified
vibration values, always check the following:
Too large a clearance between the working
tool's shank and the chisel bushing will
generate increased vibrations. To avoid getting
exposed to excessive vibrations, check the
chisel bushing for wear every day.
If the machine has a vibration-absorbing
◆
handle/handles, check that it moves freely (up
and down) and does not jam.
◆ Change damaged parts immediately.
Replace worn components in good time.
◆
Make sure that all the attached and related
◆
equipment, such as hoses, water separators
and oilers are properly maintained.

Periodic maintenance

After each operating period of approximately 150
impact hours or twice a year the machine must be
dismantled and all parts be cleaned and checked.
This work must be performed by authorised staff
who are trained for this task.

Tightening torques

A
A. Air inlet nipple: 65-75 lbf/ft (88-102 Nm), use
Loctite® 243™ (Loctite is a registered
trademark of Henkel Corporation. 243 is a
trademark of Henkel Corporation.)
B. Nut: First tighten the four nuts diagonally with a
torque of 15 lbf/ft (20 Nm). Then tighten the
nuts in sequence using the same torque. This is
to allow the nylon bumper to set properly.
C. Nylon bumper

Troubleshooting

If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
◆ Check that the working tool being used has the
correct shank dimension.
9800 0616 71 | Original instructions
All manuals and user guides at all-guides.com
C
B
Safety and operating instructions
◆ Check that the pneumatic machine is getting
the correct amount of lubricant. Too much
lubrication can cause starting problems, low
power or uneven performance.
Check that the compressed air system supplies
◆
the machine with sufficient air pressure to give
full power.
◆ Check that the dimension and length of the air
hose are according to the recommendations.
See "Installation".
If there is a risk of freezing, check that the
◆
machine's exhaust ports are not blocked.
◆ If the machine function is still not satisfactory
after this procedure, contact an authorised
service workshop.

Storage

Clean the machine properly before storage, in
•
order to avoid hazardous substances. See
"Dust and fume hazard"
Pour approximately ⁄
•
1
2
the air inlet nipple, connect the machine to the
compressed air supply and start it for a few
seconds.
Always store the machine in a dry place.
•

Disposal

A used machine must be treated and disposed of
in such a way that the greatest possible portion of
the material can be recycled and any negative
influence on the environment is kept as low as
possible, and in respect to local restrictions.
oz (5 cl) of oil directly into
19