Basic Operations; Read The Glossary; Turning Headset On/Off - Jabra BT 250 Manual Del Usuario

WARNING: Do not attempt to charge Jabra BT250 with anything other than the AC
adaptor provided. Using another AC adaptor may damage or destroy the headset.
IMPORTANT: The blue indicator light will be on while charging and will turn off
when charging is complete. Removing the headset from the charging cradle while it's
charging will put the headset into standby mode and stop the charging sequence.
IMPORTANT: Jabra BT250 cannot be used while charging.
3

Read the glossary

Read the glossary at the end of this document to familiarize yourself with important
terms used in this User Manual.
Once Jabra BT250 is fully charged, continue with these instructions.
4
"Pair" to your Bluetooth phone
3
Pairing will create a unique and encrypted wireless link between two Bluetooth
enabled devices such as your Bluetooth phone and Jabra BT250.
1. Ensure the headset is off (see Turning headset
on/off section).
until you see a solid blue light
2. Press and hold
(approximately 8 seconds), then release*
(see Fig. 2).
3. Set your Bluetooth phone to "discover" the
headset by following your phone's instruction
guide. Typically, the steps involve going to a "setup",
"connect", or "Bluetooth" menu on your phone and
then selecting the option to "discover" a Bluetooth
device.
4. Your phone will find the "Jabra BT250" headset and ask
if you want to pair with it. Confirm this by pressing "yes" or "ok".
4
5. Enter passkey or PIN = 0000 (4 zeros), then press "yes" or "ok".
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing every 3 seconds. If unsuccessful, the light remains solid,
and you'll need to reattempt pairing (see steps 3–5 above).
4
All manuals and user guides at all-guides.com
Fig. 2
Fig. 3
* If you have a Bluetooth phone that supports the hands-free Bluetooth profile,
see Enhanced features section for alternative pairing instructions. Phone-
specific pairing instructions can be found online at www.jabra.com/fscs

BASIC OPERATIONS

5

Turning headset on/off

What you do
Press and hold for 3 to
Turning
headset on 5 seconds until you see a
burst of flashes on the blue
indicator light, then release
Turning Press and hold for 3 to
headset off 5 seconds until you see a
burst of flashes on the blue
indicator light, then release
Status indicators
What you see What you hear
Flashes every Quick series of 2 tones
second – low to high pitch (when
active mode starts)
Flashes every Quick series of 2 tones
3 seconds – high to low pitch (when
standby mode starts)
3 flashes every 3 beeps every 30 seconds
second
3 flashes every 3 beeps every 5 minutes
3 seconds
*
Depending on phone type and usage.
What you hear What you see
Ascending The blue indicator
(low-to-high) light will flash while
tones the power is on (see
Status indicators
table below)
Descending The blue indicator
(high-to-low) light will stop
tones flashing
Status
5
Active Mode
•
Call in progress
•
Up to 8 hours of talk-time*
6
Standby Mode
•
Waiting for call
•
Up to 240 hours of
standby time*
Low Battery (in active mode)
•
3 – 5 minutes of talk time left
Low Battery (in standby mode)
•
3 – 5 minutes of talk time left
5