Transport And Handling; Unpacking And Handling; Packing Disposal; Setting Up - WAGNER VKM592 Manual De Uso Y Mantenimiento

2.1 Unpacking and handling

- The machine is supplied protected by a top paper cover.
Wear safety gloves and cut straps with scissors and
withdraw the paper from the machine top. Hoist the
compressor using a lifting equipment with suitable power
(see attached table).
- Fit the wheels and/or the anti-vibrating elements (where
not already fitted) (fig. 2).
- Pay attention to the accessories contained into the
packing case, then verify the perfect integrity of your
compressor.
Any further claims will not be accepted.

2.2 Packing disposal

Save the packing material in case you ever need to
transport the compressor in the future. We recommend
that you store the packing in a safe location, at least within
the period of the guarantee. In case of need, it will be easier to send the compressor to the
service centre.
Afterwards, put it into the care of the company or board in charge of elimination.

3.1 Positioning

- In order to avoid damaging the compressor, do not tilt
the compressor transversally or longitudinally more than
15° (fig. 3).
- In order to ensure proper air flow, rear ventilation grills
of compressors shall be fitted or positioned at least 50 cm
away from any obstacles which may prevent air from
flowing out correctly.

3.2 Installation

All compressors are delivered only after a successful
testing period at the factory.
- Make sure that the level of oil ranges between the max.
and min. mark (fig. 4).
- After the first 50 working hours, replace the oil with one
of those listed in the table (see § 4.10).
Power compressors
Check that mains power corresponds to the power data
written on the label.
SINGLE-PHASE: please note that the compressor is
equipped with a plug type EEC 7. If any adaptation is
necessary, have the plug replaced by a qualified
electrician.
THREE-PHASE: (fig. 5) make sure that the main supply is fitted with a switch of suitable
amperage for the total installed power. Follow relevant instructions in the table Chap. 5.
Explosion engine compressors
All checks of the explosion engine should be carried out following instructions at Chap.
“Before starting”.
All manuals and user guides at all-guides.com

2. TRANSPORT AND HANDLING

3.SETTING-UP
E / 4
15°
15°
MA X
MA X MIN
MIN
2
3
4