Programming; Preprogrammed Number Pads; Multiple Heating Stages - Amana RFS511MP Serie Manual De Instrucciones

Programming

Preprogrammed Number Pads

1. Open oven door.
• Display shows
• Fan and light operate.
• If door is closed or
before finishing programming sequence, oven
exits programming mode.
2. Press and hold pad 1 for approximately 15
seconds.
• After 15 seconds, signal sounds. Display
shows "P".
3. Press desired number pad.
• Display shows heating time and power level
indicator (if other than 100 percent power), and
pad number.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press 2 , 3, and 0 pads.
5. Press a power level pad (if power level other than
100 percent is required).
• Display shows current power level indicator
(if other than 100 percent power).
6. Press (START) pad to save new heating time
and power level in oven memory.
• Display shows "P".
• Repeat step 3-8 to program additional pads.
7. Press (RESET) pad or close oven door to exit
programming mode.
All manuals and user guides at all-guides.com
.
(RESET) pad is pressed

Multiple Heating Stages

Oven can be programmed to perform 4 independent
heating cycles without interruption.
1. Open oven door.
• Display shows
• Fan and light operate.
• If door is closed or
before finishing programming sequence, oven
exits programming mode.
2. Press pad 1 for approximately 15 seconds.
• After 15 seconds, signal sounds. Display shows
"P".
3. Press desired number pad.
• Display shows heating time and power level
indicator (if other than 100 percent power),
and pad number.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press 2 , 3, and 0 pads.
5. Press a power level pad (if power level other than
100 percent is required).
• Display shows current power level indicator
(if other than 100 percent power).
6. Press (TIME ENTRY) pad.
• Display briefly shows "P2" indicating menu,
programming stage. Then cook time and power
level for stage show in display.
• Repeat steps 5-8 to create up to 4
additional stages.
7. Press (START) pad to save new heating time
and power level in oven memory.
(RESET) pad or close oven door to exit
8. Press
programming mode.
10
.
(RESET) pad is pressed