Reviewing Preprogrammed Pads; Manual Time Entry - Amana RFS511MP Serie Manual De Instrucciones

Reviewing Preprogrammed Pads

1. Open oven door.
• Display shows
• Fan and light operate.
• If door is closed or
before finishing programming sequence, oven
exits programming mode.
2. Press and hold (TIME ENTRY) pad for
approximately 15 seconds.
• After 15 seconds, signal sounds. Display shows
"P".
3. Press desired number pad.
• Display shows heating time.
4. Press (TIME ENTRY) pad to review heating
stages for pad.
• "P" and stage show briefly, then heating time.
5. Press (START) pad after reviewing
preprogrammed pad.
• Repeat steps 3-6 to review another
preprogrammed pad.
6. Press (RESET) pad or close oven door to exit
programming mode.
All manuals and user guides at all-guides.com
.
(RESET) pad is pressed

Manual Time Entry

1. Open oven door, place food in oven, and close oven
door.
• Display shows
• Fan and light operate.
• If pad is not pressed in 30 seconds, open and
close oven door again.
2. Press (TIME ENTRY) pad.
• Display shows "0000" and
3. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press 2 , 3, and 0 pads.
4. Press a power level pad (if power level other than
100 percent is required).
• Display shows current power level indicator
(if other than 100 percent power).
5. Press (START) pad.
• Oven operates and time counts down.
• Display shows
is present.
• If power level other than 100 percent power was
programmed, display shows power level indicator.
6. Oven stops heating and oven signal sounds when
heating timing elapses.
9
.
.
only when microwave energy