Care And Maintenance - Kinderkraft GRANDE PLUS Manual Del Usuario

VIII. SAFETY STRAPS
The buggy's straps are adapted in such a way to enable its use even by new-borns. Always use the fastening system.
To secure the child, connect the latches of the hip and shoulder straps and then insert them into the middle clasp until it
engages (FIG. 18A). Adjust the straps each time. Removing the straps (for cleaning): Take the shoulder and hip straps out
of the openings (FIG. 18B).
IX. SEAT COVER REMOVAL
Remove the canopy, safety straps and safety bar. To remove the seat cover, unfasten the press studs located on the
buggy frame (FIG. 19A) and take the cover off the hooks located next to it (FIG. 19B). Then unfasten the middle Velcro
fastener located under the seat (FIG. 20A) and the strap under the footrest (FIG. 20B), and remove the cover. Install the
seat following the steps described above in reverse order.
Caution! In order to clean/wash the seat, remove all reinforcing
pads attached by Velcro fasteners in the three seat parts.
X. FOLDING THE BUGGY
When folding the buggy, press the two lock buttons located by the handle for parents (FIG. 21). Then fold the buggy
following the arrows (FIG. 22).
XI. CARE AND MAINTENANCE
The buyer is responsible for proper installation of all functional elements as well as for carrying out all required
maintenance and adjustments in order to keep the buggy in good technical condition. The buggy must be periodically
checked for potential problems. Significant measures to be applied to ensure the child's safety and prevent shortening of
the product life have been presented below:
• Check the strength and safety of all rivets and connections.
• Check all wheel locking equipment and tyres. If necessary, replace or repair.
• Check if all safety devices work properly, particularly the main and additional fasteners that should move freely at any
time.
Please stop using the buggy if there are doubts as to its proper use or a suspicion of any danger. If the wheels squeak,
apply a thin layer of silicone. Do not use oil or grease based products as they attract dirt, which makes buggy movement
difficult.
XII. CLEANING
If the elements of the buggy chassis have been exposed to saltwater, rinse with tap water as soon as possible.
Clean the product gently with a damp cloth and a mild detergent. The seat cover can be washed at 30°. To do it, remove
the cover following the steps described in Item X. Do not fold or store the product when it is wet and never store it in wet
conditions, as it can lead to mould growth.
C. Warranty
1. All Kinderkraft products are covered by a 24-month warranty. The warranty period starts from the date the product is
handed over to the Buyer.
2. The warranty is only valid in the member states of the European Union, excluding overseas territories (as currently
defined, including in particular: Azores, Madeira, Canary Islands, French Overseas Departments, Åland Islands, Athos,
Ceuta, Melilla, Helgoland, Büsingen am Hochrhein, Campione d'Italia and Livigno) and the territory of the United
Kingdom of Great Britain and Northern Ireland excluding the British Overseas Territories (e.g. Bermuda, Cayman
Islands, Falkland Islands).
3. The manufacturer's warranty does not apply to countries not listed above. The conditions of the additional warranty
may be determined by the Seller.
4. In some countries, it is possible to extend the warranty to a limited period of 120 months (10 years).The complete
terms and conditions and the warranty extension registration form are available at WWW.KINDERKRAFT.COM
5. The warranty is valid only in the territory indicated in paragraph 2.
6. Claims must be made by completing the form available at WWW.RMA.KINDERKRAFT.COM
7. The warranty does not cover:
A. Cosmetic damage, including but not limited to: scratches, dents and cracks in plastic, unless the failure is due to a
material or manufacturing defect;
B. Damage resulting from misuse or poor maintenance - including but not limited to: mechanical damage to products
caused by misuse or poor maintenance;
○ Refer to the instructions for use and installation of the product contained in the user manual;
C. Damage caused by improper assembly, installation or disassembly of products and/or accessories;
○ Refer to the instructions for use and installation of the product contained in the user manual;
D. Damage caused by corrosion, mould or rust, resulting from improper maintenance, care and storage;
E. Damage caused by normal wear and tear or otherwise resulting from the normal passage of time;
23