Brandson Equipment 305698 Manual Del Usuario página 25

• To start the appliance, press the "
heater now starts to emit cold air.
• Press the "
start heating if the set temperature is higher than the room temperature. If
the current temperature is higher than the set temperature, the appliance
only starts heating if the temperature falls below the set value.
• The symbol of the heat setting display (9) starts glowing. The fan heater has
2 heat settings. Heat setting 2 is active if two "
• As an alternative to setting the temperature, you can directly press the heat
setting button "
stop when a certain temperature is reached.
• You can also manually set whether you want to activate heat setting 2 or
heat setting 1. Press the "
6. Timer function
You can enable the timer function by pressing the "
configured time setting is displayed. You can select between 1 to 7 hours in incre­
ments of 1 hour. Please refer to the following table for the respective steps and
the corresponding illuminated LEDs.
Timer LEDs
none
1 h
2 h
1 h + 2 h
4 h
4 h + 1 h
4 h + 2 h
4 h + 2 h+ 1 h
English
" button to adjust the desired temperature. The heater will
" and the fan heater heats continuously and does not
" symbol on the control panel.
" button on the control panel. The fan
" symbols are displayed.
" button. The currently
Timer time
Timer switched off
Timer 1 hour
Timer 2 hours
Timer 3 hours
Timer 4 hours
Timer 5 hours
Timer 6 hours
Timer 7 hours
25