I.Introduction
1.Please read instructions before using this appliance.
2.When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock and injury.
3.Clean machine thoroughly before and after each use following the cleaning instructions provided below.
II.Specifications
ITEM NAMES
Bulb Warmer
III.Electrical Requirements
Plug warmer into a grounded outlet with correct voltage and sufficient power capacity. Refer to the product
label (serial plate) on the warmer for voltage and wattage requirements.
IV.Safety Instructions
WARNING! All power must be disconnected at power source before any service procedure is
performed.
This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep
1.
combustible materials, such as drapes and other furnishings, away from appliance.
Extreme caution is necessary when any appliance is used by or near children and whenever the
2.
appliance is left unattended.
Always unplug appliance when not in use and before cleaning, adjusting or maintaining this machine. To
3.
disconnect appliance, turn switch off and remove plug from power source.
Do not operate any appliance with a damaged cord or plug, after the appliance malfunctions, has been
4.
dropped or damaged.
Do not use outdoors. This appliance is not intended for wet or moist locations. Never locate appliance
5.
where it may fall into water.
Connect to property grounded outlets only. Avoid the use of extension cords. Do not run cord under
6.
carpeting, runners or the like. Arrange cord away from traffic area and where it will not create a tripping
MODEL
CW500
POWER
250Watt each bulb
VOLTAGE
220V/50Hz
8