Safety Instructions; Permitted Use - Whirlpool LR TDLR 6040S EU/N Manual De Instalación

.

SAFETY INSTRUCTIONS

Before using the appliance, read these safety
instructions. Keep them nearby for future reference.
These instructions and the appliance itself provide
important safety warnings, to be observed at all
times. The manufacturer declines any liability for
failure to observe these safety instructions, for
inappropriate use of the appliance or incorrect
setting of controls.
Very young children (0-3 years) should be kept
away from the appliance. Young children (3-8 years)
should be kept away from the appliance unless
continuously supervised. Children from 8 years old
and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge can use this appliance only if they
are supervised or have been given instructions on
safe use and understand the hazards involved.
Children must not play with the appliance. Cleaning
and user maintenance must not be carried out by
children without supervision.
Do not attempt to force the lid open.

PERMITTED USE

CAUTION: The appliance is not intended to be
operated by means of an external switching device,
such as a timer, or separate remote controlled
system.
This appliance is intended to be used in
household and similar applications such as: sta
kitchen areas in shops, o ces and other working
environments; farm houses; by clients in hotels,
motels, bed & breakfast and other residential
environments: areas for communal use in blocks of
ats or in launderettes.
Do not load the machine above the maximum
capacity (kg of dry cloth) indicated in the programme
table.
This appliance is not for professional use. Do not
use the appliance outdoors.
Do not use any solvents (e.g. turpentine, benzene),
detergents containing solvents, scouring powder,
glass or general purpose cleaners, or ammable
uids; do not machine wash fabrics that have been
treated with solvents or ammable liquids.
INSTALLATION
The appliance must be handled and installed by
two or more persons - risk of injury. Use protective
gloves to unpack and install - risk of cuts.
,
.
,
,
,
2012/19/EU
(WEEE).
,
.
IMPORTANT TO BE READ AND OBSERVED
Move the appliance without lifting it by the
worktop or top lid.
Installation, including water supply (if any) and
electrical connections and repairs must be carried
out by a quali ed technician. Do not repair or replace
any part of the appliance unless speci cally stated in
the user manual. Keep children away from the
installation site. After unpacking the appliance, make
sure that it has not been damaged during transport.
In the event of problems, contact the dealer or your
nearest After-sales Service. Once installed, packaging
waste (plastic, styrofoam parts etc.) must be stored
out of reach of children - risk of su ocation. The
appliance must be disconnected from the power
supply before any installation operation - risk of
electric shock. During installation, make sure the
appliance does not damage the power cable - risk of
re or electric shock. Only activate the appliance
when the installation has been completed.
Do not install your appliance where it may be
exposed to extreme conditions, such as: poor
ventilation, temperatures below 5 °C or above 35 °C.
When installing the appliance make sure that the
four feet are stable and resting on the oor, adjusting
them as required, and check that the appliance is
perfectly to level using a spirit level.
If the appliance is being installed on wood or
" oating" oors (certain parquet and laminate
materials), secure a 60 x 60 x 3 cm (at least) sheet of
plywood to the oor then place the appliance on top
of this.
Connect the water inlet hose(s) to the water
supply in accordance with the regulations of your
local water company.
For cold ll only models: do not connect to the
hot water supply.
For models with hot ll: the hot water inlet
temperature must not exceed 60 °C.
The washing machine is tted with transport
screws and a transport bracket to prevent damage
during transport. Before using the washing
machine you must remove the transport
bracket (see "Installation guide"). After the removal,
cover the openings with the 2 enclosed caps.
Remove the bottom protection by tilting and turning
the washing machine on one rear bottom corner.
Make sure that the plastic part of the bottom
protection (if available on the model) remains in the
.
.
,
. ,
EN