Everbilt PCP10001-VSP Guía De Uso página 13

STEP 1 - START time:
Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.

Press the UP or DOWN arrows to Adjust Minutes.

STEP 2 - END time: Press ENTER button once.
Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.

Press the UP or DOWN arrows to Adjust Minutes.

PERIOD 4
If you want to set Period 4, and the display shows "4/OFF", you need to enable Period 4 by pressing the UP arrow once.
To turn Period 4 OFF again, press either the UP or DOWN Arrow during STEP 1 (when HOURS is flashing) until the display shows "4/OFF".
:
NOTICE
STEP 1 - START time:
Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.

Press the UP or DOWN arrows to Adjust Minutes.

STEP 2 - END time: Press ENTER button once
Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.

Press the UP or DOWN arrows to Adjust Minutes.

Start Automatic Mode
Press the AUTO button 3 times.
If the current time is within the operating schedule, the pump will start. If the current time is NOT within the operating
schedule, the RPM will display 4 large rotating numbers.
The pump will turn OFF and not run during gaps between time periods.
Example:
Period 1 – Start time 09:00 / End time 13:30
Period 2 – Start time 15:00 / End time 16:00
The pump will turn OFF from 13:31 thru 14:59 and turn back ON again at 15:00. The pump will display the 4 large rotating numbers during the
OFF time.
:
NOTICE Under the AUTOMATIC mode, the default startup is set at HIGH speed (3500 RPM) for the first 5 minutes. After 5 minutes, the speed will
switch to the Operation Schedule settings. This will also occur if there are gaps between time periods.
The Current Time settings will remain in place for up to 2 months after the power is disconnected. After 2 months, the Current Time must be
programmed again.
To Change the Operation Schedule:
Restore Factory Default Settings: Press and hold the UP and DOWN arrows at the same time until the Display lights turn off and on again.

This should take approximately 10 seconds.
Determine the new Operation Schedule settings.

Follow the "Program the Operation Schedule" instructions on the previous page.

STEP 3 - Operating Speed: Press ENTER button once.
Press either LOW, MEDIUM or HIGH.

Adjust the Operating Speed in 25 RPM increments by

pressing the UP or DOWN Arrow.
STEP 4 – Press the ENTER button once, the Control Panel will display
Period 4 settings.
If you are only setting Periods 1, 2 and 3, wait 7 to 10

seconds and the new settings will be saved. Then skip to
the directions for "Start Automatic Mode."
STEP 3 - Operating Speed: Press ENTER button once.
Press either LOW, MEDIUM or HIGH.

Adjust the Operating Speed in 25 RPM increments by

pressing the UP or DOWN Arrow.
STEP 4 - Wait approximately 7 seconds and the new settings will be
saved.
Congratulations, programming is complete!