Everbilt PCP10001-VSP Guía De Uso página 7

TO WIRE A VARIABLE SPEED MOTOR
:
Be sure power is off.
Remove the terminal box lid. (FIG.1)

Use multifunction crimping pliers to press O-type grounding terminal which connects 14 AWG. (FIG.2)

Install 1/2" connector to terminal box. Install ground wire to ground rod using multifunction crimping pliers to connect two wires with two

wire caps. (FIG.3)
Install conduit to connector. (FIG.4)

Reinstall the terminal box lid.

Connect a No. 8 AWG solid copper bonding wire to the pressure wire connector provided on the motor housing and to all metal parts of the

swimming pool, spa, or hot tub and to all electrical equipment, metal piping or conduit within 5 feet of the inside walls of swimming pool,
spa, or hot tub.
Follow all national and local wiring codes. If unsure of the code requirements, consult a professional electrician.

Pump must be permanently connected to circuit. Table I gives correct wire and circuit breaker sizes for the pump alone. If other lights or

appliances are also on the same circuit, be sure to add their amp loads to pump amp load. If unsure, consult a licensed electrician.
A ground fault circuit interrupter (GFCI) is required in the circuit. For size of GFCI required and test procedures for GFCI, please see

manufacturer's instructions.