Bosch 30-300 Instrucciones De Funcionamiento Y Seguridad página 13

Fig. 7
a
3
2
marking ring 17 by one with another colour or
to adjust the worklight. Adjust the worklight to
the desired position first (see "Adjusting the
Worklight" , page 11) before adjusting the angle
head.
– Loosen the lock nut 22 by inserting an ap-
propriate tool into an opening of the lock nut
and turning the lock nut in the direction of
the arrow a (left thread).
160992A3VR.indb 13
All manuals and user guides at all-guides.com
– Unscrew the angle head 3 in arrow direction
22 23
– Unscrew the lock nut 22 from the motor
Now, the marking ring can be exchanged or
the worklight can be adjusted.
– Turn the lock nut 22 in arrow direction c
c
– Lock the angle nutrunner head by screwing
17
b
– Retighten lock nut 22 again with a tighten-
CONFIGURING THE POWER TOOL
With the BOSCH EXACT Configurator soft-
ware, different power tool settings (e. g.,
speed, driving stages, repeat protection) can
be configured. For this, the power tool must
be connected to a PC via the USB data port.
Note: Observe all safety warnings and in-
structions in the software instruction manual.
13
b until it can be removed.
housing 23 in arrow direction a.
onto the motor housing 23 and screw on the
angle head again turning in arrow direction
b.
the lock nut 22 in arrow direction c.
ing torque of approx. 50 Nm.
3/7/17 12:22 PM