Bosch 30-300 Instrucciones De Funcionamiento Y Seguridad página 12

Bosch part number
Maximum torque,
hard screwdriving
application according
to ISO 5393 Nm
Tightening torque at
the flange Nm
Accessories for
ANGLE EXACT ION
Weight according
to EPTA-Procedure
01/2003 kg
MOUNTING THE ANGLE HEAD
Applies for the following types: ANGLE
EXACT ION 3-500, 8-1100, 15-500, 23-380,
30-290.
On these industrial cordless angle wrenches,
a fitting angle head (see "ANGLE HEADS" , )
has to be mounted first.
Fig. 6
20
3
4
– Hold the power tool with the open-end
spanner 21 by the spanner flats 4 of the
angle head flange (Fig. 6).
Never clamp the tool by
the housing shells!
– Mount the angle head 3 onto the flange
in the requested position and tighten the
sleeve nut with the open-end spanner 20
via the spanner flats 5.
Hold the angle head flange with the open-end
spanner 21 to prevent turning.
160992A3VR.indb 12
All manuals and user guides at all-guides.com
ANGLE HEADS
Angle head
1/4" 3/8"
0607453617 0607453620 0607451618
20 25
20 20
15-500 15-500
0.2 0.2
The angle head 3 can be adjusted to a total of
eight positions.
– Hold the power tool with the open-end
– Loosen the sleeve nut with the open-end
21
ADJUSTING AND REMOVING THE
Applies for the following types: ANGLE EX-
ACT ION 30-300, 40-220, 50-210, 60-120.
5
The angle head 3 with tool bit holder 2 can
be continuously adjusted around 360° (Fig. 7).
– Loosen the lock nut 22 by inserting an ap-
– Fix the angle head 3 in this position by turn-
– Turn the angle head 3 in arrow direction b
The angle head 3 can also be removed com-
pletely, e. g. when it is required to replace the
12
3/8"
1/4" QC
0607453618 0607453630
30 20
25 20
30-300 15-500 15-500
0.2 0.2
ADJUSTING THE ANGLE HEAD
spanner 21 by the spanner flats 4 of the
angle head flange.
Never clamp the tool by
the housing shells!
spanner 20 by the spanner flats 5. Adjust
the angle head 3 in 45° steps to the desired
position and retighten the sleeve nut again
with the open-end spanner 20 by the span-
ner flats 5. Hold the angle head flange with
the open-end spanner 21 to prevent turning.
ANGLE HEAD
propriate tool into an opening of the lock nut
and turning the lock nut in the direction of
the arrow a (left thread).
ing the lock nut 22 in the direction of the
arrow c against the angle head. Tighten the
lock nut 22 with a tightening torque of max.
50 Nm again.
until the desired work angle is reached, but
not more than once by 360°.
Straight
drive head
1/4" QC 1/4"
0607453 631
20 6
20 10
15-500
0.2 0.2
3/7/17 12:22 PM