Structure And Access Rights To The Operating Software - Weidmuller CRIMPFIX ECO Traduccion Del Manual De Instrucciones Originales

5.10 Structure and access rights to the operating software
Sub-menu 2nd level
Cross-section / Status /
piece counter
1/2 cross-section
1/2 language
2/2 Start monitoring
2/2 Button sounds
1/1 Reference run, jog mode
forwards
Jog mode
1/1 Reference run, jog mode
forwards and backwards
1/1 Start / Magazine stop / Cover
Status I/O
status
1/1 Q1 / Q2 / Q3
Status I/O
2/2 A1 / A2 Off/On
Status I/O
2/ 2 temperature, voltage
Status I/O
Stripping / position
Cutting blade
Stripping / reference
Cutting blade
Separate / position
Cutting blade
Cut / reference
Cutting blade
Input four digit code
Users
1/3 Software
1/ 3 Reset piece
counter
1/3 Total
1/3 Service
1/3 Day
2/3 Default settings
2/3 Endurance test
2/3 Software
3/ 3, Piece counter, type
2859970000/00/02.2022
Access rights Description
Production
Operator Display during operation, changing menu settings
Setting
Operator Setting the conductor cross-section display
Operator Setting the language
Operator Start sensor must be pressed longer: Yes/no
Operator Touch display sound: Yes/no
Service
Reference run back to the starting position
Operator
Complete crimping cycle forwards step by step
Reference run back to the starting position
Installer
Complete crimping cycle backwards step by step
Operator Check status in case of a malfunction, forward info to service personnel.
Operator Check status in case of a malfunction, forward info to service personnel.
Installer Switch outputs A1 and A2 (not active) off and on
Installer Current temperature inside the machine and current voltage
Installer Approach the position to exchange the stripping blade
Installer Reference run back to the starting position
Installer Approach the position to exchange the separating blade
Installer Reference run back to the starting position
Installer code = 1212.
Operator
Enter any code to set the operator.
Info
Operator Installed software version
Operator Reset daily piece counter to 0
Operator Crimp cycle total piece counter
Operator Crimp cycle service piece counter
Operator Crimp cycle daily piece counter
Installer Reset all values to the default settings
Installer Switch the endurance test on or off
Installer Start an operating software update
Service Reset the total piece counter, set the type
Operating software
41