Stainless Steel; Carbon Filter - Jocel JCEI60-014573 Manual Del Usuario

GENERAL
Cleaning and maintenance should be carried out with the appliance cold especially when
cleaning. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.

STAINLESS STEEL

The stainless steel must be cleaned regularly (e.g. Weekly) to ensure long life expectancy. Dry
with a clean soft cloth. A specialized stainless-steel cleaning fluid may be used.
NOTE:
Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly
crisscross scratching patterns from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and
well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after
cleaning.
Important
Using neutral detergents and avoid using harsh cleaning chemicals, strong household
detergents or products containing abrasives, as this will affect the appliance appearance and
potentially remove any printing of artwork on the control panel and will void manufactures
warrantee.
Note: Carbon filters will not be washed, they will be replaced once every 2 to 6 months,
depending on the frequency of use.
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. There should be used 2 units of carbon
filters. The installation procedure of activated carbon filter is as below.
1. Before installing or replacing the carbon filters, disconnect the mains power to the unit.
2. Press the filter lock and remove the grease filters.
3. Place and turn each of the carbon filter 90º (quarter of turn) until a "click" sound is heard
on both sides of the motor.
4. Put the grease filters back.
5. Connect the mains power supply to the wall socket.
NOTE:
• Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.
23