Machine Information; Technical Specifications - VONROC S CS503AC Traducción Del Manual Original

EN

2. MACHINE INFORMATION

Intended use
This mini plunge saw is intended for sawing
different types of thin material for home use. It is
perfect for confined spaces. This saw is handheld,
compact, lightweight and can harness enough
power and speed to saw materials such as sheet
wood and tiles.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power input
No load speed
Saw blade size
Sawing capacity 0°
Weight (excl. guiderail)
Sound pressure level L
Sound power level L
WA
Vibration
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN62841; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-5.
10
S_CS503AC
230-240 V~
50 Hz
500W
3500-6500/min
Ø85 x Ø15mm
22mm
1.7 kg
93 dB(A), K=3dB(A)
PA
104 dB(A), K=3dB(A)
a 2.63m/s² K=1,5m/s²
h,W
a 2.47m/s² k=1.5m/s²
h,M
1. Protective cover
2. Handle
3. Saw depth limiter
4. On/Off switch
5. Handgrip
6. Rear ventilation hole
7. Speed adjustment
8. Dust extraction pipe
9. Depth indicator
10. Sawblade
11. Guide rail
12. Coupling bar
13. Clamp
14. Rail guide
15. Rail guide bolt
16. Support plate
17. Hex bolt (5mm)
18. Washer
19. Hex key
20. Cap nut
21. Hex bolt (15mm)
22. Parallel guide
23. Adjustment knob
24. Spindle lock button
25. Mounting flange
26. Clamping nut
Blade specifications
Included with the machine are three different type
blades:
Blade
General long-life 24T TCT blade
Diamond blade
Fine 44T HSS blade
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting the support plate (Fig. B-1)
• Mount the support plate (16) on the machine
using the 5mm hex bolt (17) and washer (18)
as shown in figure B-1. Place the notch on the
support plate in the cam of the machine.
Purpose of use
Wood and plastics
Ceramics (dry cut)
Wood and plastics
WWW.VONROC.COM