Machine Information; Technical Specifications - VONROC WC503AC Traducción Del Manual Original

EN
• Avoid dust accumulation in the workplace.
Dusts can easily ignite.
• Ensure adequate ventilation in closed rooms.
Risk due to dust and impaired vision.
• Dust from materials such as coatings contai­
ning lead, several types of wood, minerals and
metals can be harmful to health and cause
allergic reactions, respiratory diseases and/or
cancer. Asbestos-containing material may only
be machined by specialists.
- Wherever possible, use a industrial type
vacuum cleaner suitable for the material you
are working on.
- Ensure the workplace is properly ventilated.
- Observe the relevant regulations in your
country for the materials to be machined.
• Keep power cord away from rotating working
tools. Loss of control over the power tool can lead
to cutting or catching the power cord, also hand
or whole arm can get into rotating work tool.
• Do not carry power tool when it is rotating.
Accidental contact of rotating working tool with
clothes may cause its catching and plunging of
working tool into operator's body.
• Do not start working before the power tool
reaches its full rotary speed.
• Do not expose diamond dry­cutting discs to
lateral pressure.
• Never use diamond dry­cutting discs for rough
grinding.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
Class II machine - Double insulation - You
don't need any earthed plug.
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
8

2. MACHINE INFORMATION

Intended use
This power tool is designed for dry cutting in
masonry (brick, lime-sand blocks, undressed
stone) and concrete. It must not be used for wet
cutting or for cuts in metal, glass, wood, etc.

TECHNICAL SPECIFICATIONS

Model no.
Model no. cutting disc
Mains voltage
Mains frequency
Power input
No-load speed
Disc diameter
Disc bore
Max. cutting depth
Cutting width
Weight
Sound pressure (LPA
Acoustic power (LWA)
Vibration ah
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardised test given in EN 60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
• using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level
• the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared supply
WC503AC
WC802AA
230 V~
50 Hz
2400W
8000 /min
150mm
22,2mm
43mm
30mm
6,2 kg
97 + 3 dB(A)
108 + 3 dB(A)
10,94 + 1,5 m/s²
WWW.VONROC.COM