Operating Modes; Standard Mode; Using The Remote Control - Indel B K CELLAR 36 ECOSMART Instrucciones Para El Uso

Ocultar thumbs Ver también para K CELLAR 36 ECOSMART:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Start-up and use

OPERATING MODES

STANDARD MODE

In this operating mode, only the power cord is connected to the appliance.
In this operating mode, only the power cord is connected to the appliance.
The temperature is constantly regulated by the thermostat to the level set from the oper-
The temperature is constantly regulated by the thermostat to the level set from the oper-
ator panel and indicated by LEDs 1-2-3, with an error margin of ± 1° C (see temperature
ator panel and indicated by LEDs 1-2-3, with an error margin of ± 1° C (see temperature
settings table).
settings table).
The appliance is recommended to be used at 9°C (thermostat setting on "MIN") for the best
The appliance is recommended to be used at 9°C (thermostat setting on "MIN") for the best
maintaining of the foodstuffs.
maintaining of the foodstuffs.
TIMER
TIMER MODE
In this operating mode, only the power cord is connected to the appliance.
In this operating mode, only the power cord is connected to the appliance.
The appliance operates only within the temperature ranges set using the remote control
The appliance operates only within the temperature ranges set using the remote control
and the temperature is constantly regulated by the thermostat to the level set from the
and the temperature is constantly regulated by the thermostat to the level set from the
operator panel and indicated by LEDs 1-2-3, with an error margin of ± 1° C (see temper-
operator panel and indicated by LEDs 1-2-3, with an error margin of ± 1° C (see temper-
ature settings table).
ature settings table).

USING THE REMOTE CONTROL

Open
P1
P2
P3
P4
-
+
SET
ON
OFF
189A1018
The appliance comes with a remote control unit that allows the user to set the compressor
to operate at certain times of the day. Each refrigerator has three pre-set operating peri-
ods and one (P4) that can be programmed by the user. A maximum of two on/off cycles
can be set every 24 hours. The remote control is easy to use. Once you have selected
the programme from the remote control, simply point it at the receiver to the right of the
control panel (from a distance of about 30-40 cm). Press and hold
the button of the selected programme on the remote control for
at least two seconds: the appliance switches on. The display will
show the following symbol.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido