Technical Data; Safety; General Safety Rules When Using Induction Heater - BGS technic 3391 Instrucciones De Uso

1.6

TECHNICAL DATA

Input voltage
Frequency
Maximum input current (6.3 A circuit breaker)
Maximum input power
Output frequency
Power factor
Maximum working cycle
Protective system
Protection class
Dustiness class
Weight
Dimensions
1) For the purposes of measurement pursuant to EN 60335-1, the maximum current and power
output are determined as nominal values under nominal supply voltage U=230 Vac / 50 Hz,
during normal operation and with the load configuration: Inductor "80-108-01" and working object
"Bar with a diameter D=45 mm made of unalloyed steel of class11 (S235JRG2)" inserted in the
inductor with a length of 75 mm and heated to 100°C. The output power is read after 2 minutes of
heating.
2

SAFETY

2.1

GENERAL SAFETY RULES WHEN USING INDUCTION HEATER

Symbols shown in this Manual warn and identify potential hazards when handling the device.
-
Do not leave INDUCTION HEATER unattended while it is turned on. Always deactivate
INDUCTION HEATER with the master switch when not using it for heating!
- Whenever the device is connected to the grid power supply, sufficient air supply for cooling
has to be provided.
-
Make sure that the ventilation openings are free of dust and dirt, to not preclude flow of air.
- Do not attempt to repair your INDUCTION HEATER. The device contains no parts that the
user could repair.
-
The user is responsible for the device installation and use in accordance with instructions
shown in this Manual.
-
The supplier is not liable for any damage due to inexpert use and operation.
-
Keep persons standing around and animals at a safe distance while working with the
INDUCTION HEATER, including while the heated material is cooling down.
-
Keep the working area well ventilated and dry, clean and well lit.
! The device must be protected from rain and moisture, mechanical damage and any
ventilation of adjacent machines, excessive overloading and harsh handling!
SYMBOL
DANGER! Denotes a dangerous situation that may result in a death or serious injury.
The potential risks are shown under the following symbols, or explained in the text.
Before plugging in your INDUCTION HEATER, make sure the socket voltage matches
that on the product plate. If the power grid socket voltage does not match that shown on
the type plate, it can result in a serious hazard and damage to your INDUCTION
HEATER.
IMPORTANT! Read this Manual carefully to familiarize yourself with the risks and
working method of the INDUCTION HEATER.
Inappropriate handling may cause death, injury, material damage or irreversible
damage to your INDUCTION HEATER.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
5
375x65x85
EXPLANATION
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
230
50/60
5,4
1,2
40-60
IP20
I.
II.
1
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
V
AC
Hz
A 1
RMS
kW
kHz
kg
mm