Heating Inductors For Induction Heater And Rules For Their Use; Front And Side Socket Coils - BGS technic 3391 Instrucciones De Uso

4

HEATING INDUCTORS FOR INDUCTION HEATER AND RULES FOR THEIR USE

4.1

FRONT AND SIDE SOCKET COILS

Standard front and side socket coils are used for heating nuts, clutches, gaskets, hinges, exhaust
pipes, bolts, etc., which are accessible for sliding on the coil.
FRONT COILS
Standard diameters: 15-45 mm
SIDE COILS
Standard diameters: 15-45 mm
Rules for correct use:
There should be a gap of approximately 3-5 mm between the coil and the heated material while
heating it to prevent excessive wear of the coil insulation. Holding the coil directly on the hot
material may burn the coil insulation, reducing coil lifetime. We recommend keeping direct contact
between the coil and hot material to a minimum.
REMARK: Releasing of nuts, bolts, etc., typically does not require making the material red-hot.
Heat the nut for 2 seconds and try to loosen it with a wrench. If you cannot, heat it for another 2
seconds and try to loosen it with a wrench again. Coil lifetime can be increased by removing rust,
paints, lubricants, etc., from the heated material.
CAUTION: Use original heating inductors only. If non-original accessories are used, the device
manufacturer is not liable for any damage due to device use. Use of a non-original inductor is
considered use in contravention of the Instruction Manual
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
12
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed