Flat Inductor; Environmental Protection; Disposal - BGS technic 3391 Instrucciones De Uso

4.3

FLAT INDUCTOR

The flat spiral-shaped coil is designed for heating flat sheet metal and straightening minor dents in
car bodywork by heating. The flat coil is also intended for easy removal of stickers, rubbers,
gaskets, sealants and the like by heating the substrate – sheet steel.
Correct procedure:
1. Connect the coil to the coil holder.
2. Apply the coil surface to the material.
3. Press the button and guide the coil a circular movement over the material.
4. After heating the material, leave the coil to cool for at least 2 minutes.
REMARK: The coil can be used for removing various stickers, rubber linings and gaskets glued on
a metal or sheet metal material, e.g., in the automotive industry, car repair shops, etc. The coil is
used for heating the substrate, thus softening or hardening the adhesive, sealant, etc. We
recommend holding the coil approx. 5-15 mm from the heated material; the required temperature
and heating speed can be adjusted by changing the distance.
CAUTION: Use original heating inductors only. If non-original accessories are used, the device
manufacturer is not liable for any damage due to device use. Use of a non-original inductor is
considered use in contravention of the Instruction Manual.
5.1

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
5.2

DISPOSAL

Do not dispose electric and electronic units in household waste. They should be disposed of
in a responsible manner, they must be disposed at appropriate collection point. Dispose of
this product at the end of its working life in compliance with the EU Directive on Waste
Electrical and Electronic Equipment. Contact your local solid waste authority for recycling
information or give the product for disposal to BGS technic KG or to an electrical appliances
retailer.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
,3
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
14
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed