Using The Induction Heater; Maintenance; Storage; Commissioning - BGS technic 3391 Instrucciones De Uso

3

USING THE INDUCTION HEATER

3.1

MAINTENANCE

Persons without electrical engineering qualification are not permitted to do any servicing. Considerate
use of the INDUCTION HEATER helps prevent needless defects and malfunctions.
Contact the device vendor for any servicing.
3.2

STORAGE

The device has to be stored in a clean and dry room. Protect the device from moisture and direct
sunlight. Leave the device switched on for 10 minutes after heating, until it cools down. Then switch it
off by disconnecting it from the grid power supply. If you disconnect the device immediately, leave it
and all the working coils to cool down for at least 20 minutes.
3.3

COMMISSIONING

Unpack the device and any accessories supplied and check that they are in good order and the
device and the accessories are not damaged in any way. If you find any defects, do not continue and
contact the device vendor!
3.4

HEATING PROCEDURE

1. Slide the heating inductor over or next to the heated material, but the inductor should not touch
the heated object.
2. Press the heating button.
3. Hold the button down throughout the heating to the required temperature.
4. Release the heating button and carefully slide the inductor off the heated material.
5. Put the device down on a fireproof surface and leave it to cool for next use or cool down for 10
minutes before storage.
CAUTION
It is important not to expose your body parts to the variable magnetic field while
heating. Therefore, observe sufficient distance between all body parts and the active
inductor zones described in the picture.
CLASS 2 RISK
Red colour marks active zones, where
interaction with the magnetic field leads to a
tissue damage risk even on short exposure
to its effects.
CLASS 1 RISK
Zones marked in yellow pose a tissue
damage risk on long-term exposure to the
magnetic field effects.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
9
DANGER ZONE
DANGER ZONE
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
SAVE ZONE
SAVE ZONE
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed