Packing And Transport; Fitting The Appliance (Combi Unit + Wall-Mount Boiler) - Baxi COMBI 80 Manual Complementario Para El Uso Destinado Al Instalador

SUPPLEMENTARY INSTRUCTIONS FOR THE INSTALLER
This manual supplements the one supplied with wall-mount boilers.
The Combi unit is used to convert a heating-only wall-mount boiler into a base boiler that generates domestic hot water
thanks to a heater with a capacity of 79 litres made of AISI 316 L stainless steel.
The following technical instructions and notes are intended for installers so they may make a perfect
installation.
The instructions for igniting and using the boiler are given in the boiler manual.
The unit is sold on a wooden pallet protected by packing made of strengthened cardboard.
The packed unit must only be transported and lifted by holding it underneath the pallet.
CAUTION:
- This unit is to be combined only with a boiler.
- The bottom of the unit is secured to the wooden base with a screw.
To unscrew it, take off the cardboard packing and remove the door.
- The packing elements (plastic bags, polystyrene, etc.) must not be left within reach of children as they are potentially
hazardous.

2. FITTING THE APPLIANCE (Combi unit + wall-mount boiler)

Before installing the boiler it is necessary to fit the wall-mount boiler to the Combi unit.
• 5 Seals G 3/4" + 1 Seal G 1/2"
• Side panels
• Crosspiece for side panels + 4 self-tapping screws
• Condensation runoff pipe with clamps
• Filling hose with tap and clip..
• Delivery/storage boiler coil connection hose.
To carry out this operation, proceed as indicated in figure 1 and in the following instructions:
• Attach the filling hose and the delivery/storage boiler coil connection hose to the relative connectors;
• Take the wall-mount boiler out of its packing and place it over the unit with the front parts aligned;
• Secure at the front the boiler to the Combi unit with the side-panel brackets;
• Screw the pipes on the Combi onto the boiler's plumbing connections, inserting the seals supplied in the outfit (after
removing the G 3/4" plug on the coil delivery connection);
• Attach the G 1/2" tap to the boiler domestic cold water connector and attach the hose to the tap;
• Connect the condensate drain hose (supplied) to the boiler siphon (secured with clamps);
• Couple the side panels onto the sides of the boiler.
Insert the side panels and the crosspiece only after finishing installing the appliance.
SUPPLEMENTARY INSTRUCTIONS
FOR THE INSTALLER
INTRODUCTION

1. PACKING AND TRANSPORT

2.1 ASSEMBLY OUTFIT ON THE COMBI UNIT
17
7804282.02 - en