Klarstein ZARAH 60 Manual De Instrucciones página 21

Chimney Installation
1
Put the upper chimney into lower
chimney .Then pulling out the upper
chimney upwards. Adjust to reach the
height required.
Installation (Vent inside)
If you do not have an outlet to the outside, exhaust pipe is not required and the
installation is similar to the one show in section "Installation (Vent outside)".
Installing the Carbon Filter
Note: Carbon filter is not standard accessory, these can be purchased as an accessory.
1
Activated carbon filter can be used to
trap odours.
2
Sliding the chimney to adjust the
chimney height. When the height you
required is reached, then hang the fixing
hole to the fixing screws as showed in
picture.
2
In order to install the activated carbon
filter, the grease filter should be
detached first. Press the lock and pull it
downward.
EN
21