Rules Of Use - MSW Motor Technics MSW-BC-A Manual De Instrucciones

q) Do not recharge a frozen battery.
r) Keep the appliance away from inclement weather, especially rain/snow.
Operate the appliance in a well-ventilated room only.
s) During recharging, the battery will emit gases which are explosive. Avoid
contact with sparks or fire.
t) Do not operate the appliance in explosion hazard areas.
u) Keep the terminal clamps clean. If contaminated, the clamps may obstruct with
or prevent recharging of batteries. Always inspect the battery condition so that
the terminal clamp attachment location is kept clean.
v) The battery charging time will depend on the battery drain (state of charge) and
capacity. Verify the battery condition with reference to the manufacturer's
instructions.
w) Always unplug the charger from the mains before connecting/disconnecting the
charging leads to/from the battery.
x) Keep both terminal clamps from touching one another while the charger is
powered on.
y) Use this charger for charging standard (lead acid), AGM, and lithium batteries
only. Do not use for charging other types of batteries.
z) Do not attempt to charge dry cell batteries. Otherwise the dry cell battery may
fail and cause injury.
aa) Do not power on the device the battery of which is connected to this charger.
bb) Never attempt to recharge more than one battery at the same time.
cc) The charger may heat up in operation. Leave the appliance to cool down before
handling.
dd) Extreme caution is required when charging lead-acid batteries. Contact with the
battery acid leaking from a battery may result in severe injury.
ee) Never place the battery directly below or directly atop the charger. Keep the
battery away from this appliance.
CAUTION! Although the appliance has been designed to be safe and has
been provided with adequate safeguards, and despite the use of additional
safety measures, there is still a low, residual risk of accident or injury during its
operation. Caution and common sense are advised when using the product.

3. Rules of use

This appliance is for automatic recharging of standard (STD – lead acid), LIT
(lithium) and AGM batteries with the pole post-to-post voltage of 6 V or 12 V.
The user is responsible for any damage caused by non-intended use.