Install The Battery Pack; Remove The Battery Pack; Operation; Cold Weather Operation - GreenWorks SSF405 Manual Del Operador

1. Push the auxiliary handle (7) onto the upper shaft (8).
2. Move the auxiliary handle (7) above the metal ring (13)
and make sure that the metal ring (13) fits between the
slot on the auxiliary handle (7).
3. Align the holes on the auxiliary handle (7) and the metal
ring (13).
4. Put the handle knob (14) through the holes and tighten it.
9.4

INSTALL THE BATTERY PACK

1
English
14
16
9
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack (16) with the
grooves in the battery compartment (1).
2. Push the battery pack into the battery compartment (1)
until the battery pack (16) locks into place.
3. When you hear a click, the battery pack is installed.
9.5

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack (16) from the machine.
10

OPERATION

WARNING
Wear eye protection during operation.
10.1

COLD WEATHER OPERATION

The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
WARNING
Do not store or charge battery outside.
Battery must be charged and stored indoors prior to use of the
machine.
If the machine does not start below 1°F (-17°C),
• remove the battery pack from the machine,
• charge the battery pack for 10 minutes in warm area, or
when the charging light turns green.
• Install the battery pack again.
EN