Install The Battery Pack; Remove The Battery Pack; Operation; Cold Weather Operation - GreenWorks 2605302 Manual Del Operador

3. Align the arrows in the discharge chute and snow
thrower deck. Make sure the discharge chute faces
forward.
4. Put the end of the chute control rod (4) straight
through the hole (17) in the bracket. Keep the grip
handle down.
5. Push the chute control rod (4) into the hole (17)
behind the deck.
6. Turn the grip handle left and right to make sure that
the discharge chute moves in the same direction.
9.6

INSTALL THE BATTERY PACK

33
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Open the battery door (11).
2. Align the lift ribs on the battery pack (33) with the
grooves in the battery compartment.
3. Push the battery pack (33) into the battery
compartment until the battery pack (33) locks into
place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door (11).
9.7

REMOVE THE BATTERY PACK

1. Open the battery door (11).
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
English
10

10.1 COLD WEATHER OPERATION

The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
Battery must be charged and stored indoors prior to use
11
of the machine.
If the machine does not start:
•
•
•

10.2 START THE MACHINE

1. While holding the safety switch button (13), pull the
9

OPERATION

WARNING
Wear eye protection during operation.
WARNING
Do not store or charge battery outside.
remove the battery pack from the machine,
charge the battery pack to 15 minutes in warm area,
or when the charging light turns green.
Install the battery pack back in the unit.
1
13
bail lever (1) to start the machine.
NOTE
Lower the scraper to the ground to remove the snow.
WARNING
Keep bystanders a safe distance from the machine.
WARNING
Examine the work area. Remove all stones, sticks,
wire, bones, and other debris that can ricochet
because of the rotating impeller.
EN