Preparing For Use; Mounting The Base Unit - Bench; Attaching The Vise To The Base Unit - Oregon 310-120 Manual Original De Instrucciones

310-120

Preparing for Use

ATTENTION Do not install the machine at eye level You are recommended to install it at a height of no more than
3 9 to 4 2 feet (1 2 – 1 3 m) from the floor
Mounting the Base Unit – Bench
Bench-Mounting
Insert two (2) appropriate bolts, complete with
washers and nuts (not supplied), in the securing
holes Make sure you position the base unit hanging
over the edge of the bench as shown in the detail

Attaching the Vise to the Base Unit

Remove the vise-adjustment knob (12) from the vise
assembly (B) by unscrewing clockwise
Place the bolt on the vise assembly (B) into the hole
on the motor unit (A) and reattach the vise adjustment
knob (12)
Preparing for Use
13