Setting Up The Grinder; Electrical Connection; General Information; Using And Keeping The Operator's Manual - Oregon 310-120 Manual Original De Instrucciones

Safety Information
USE PROPER EXTENSION CORD
Make sure your extension cord is in good condition
When using an extension cord, be sure to use one
heavy enough to carry the current your product will
draw An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating
The table below shows the correct size to use
depending on cord length and nameplate ampere
rating If in doubt, use the next heavier gauge The
smaller the gauge number, the heavier the cord
Minimum Extension Cord Gauges
for 310-120 Grinder
Length
25 ft / 7 6 m
50 ft / 15 2 m
100 ft / 30 5 m
150 ft / 45 7 m
NEVER LEAVE TOOL RUNNING UNATTENDED
Turn power off Do not leave tool until
it comes to a complete stop

Setting up the Grinder

CAUTION The grinder must only be used in a
place that is protected from dust and dampness, is
well-lit, out of the reach of children, and away from
gases or other flammable or explosive liquids
Avoid using dangerous extension cables

Electrical Connection

– Make sure the electrical system power
supply complies with the values
written on the rating nameplate
– The power supply voltage must not differ from
that written on the nameplate by ±5%
– The connection to the electric mains must be
prepared subject to current standards in force
in the country in which the machine is used
8
Gauge, AWG
18
16
16
14

General Information

The manufacturer is not liable for
damages in the following cases:
– Failed observance of the instructions given herein;
– Use of the machine other than that described
in the "INTENDED USE" section;
– Failure to use in compliance with current
standards on Health & Safety at the workplace;
– Incorrect installation;
– Lack of scheduled maintenance;
– Modifications or jobs that are not
authorized by the manufacturer;
– Use of non–original or inadequate spare parts;
– Repairs that are not carried out by a specialist
Using and Keeping the
Operator's Manual
The characteristics and the information given in this
manual are merely indicative The manufacturer
reserves the right to add any modifications to the
grinder considered necessary at any time It is
forbidden to reproduce any part of this document
without authorization on behalf of the manufacturer
The operator's manual is an integral part of the
machine and must be kept in a safe place so
that it can be consulted whenever need be If you
should lose your manual or it should deteriorate,
you can request your dealer or an authorized
service center for another copy The manual
shall accompany the machine at all times

Safety Devices

The grinder is equipped with the safety
devices illustrated on page 10:
– Shield guards: they protect the operator from
parts of the grinding wheel that may come away
during the sharpening process These guards must
always be fitted in place when the machine is in use
Always make sure the guards are efficient and fitted
properly Operator safety could be compromised
if the guards are damaged and/or cracked
– Switch: the machine features a safety switch with
release coil In the case of a sudden power failure,
the switch trips automatically and disconnects
the machine from the mains The machine will
not start even if the power supply is suddenly
restored You need to restart the grinder by
turning the on-off switch to the on position,"I"
310-120