Electrical Safety; Special Safety Instructions For Woodworking Machines - HOLZMANN MASCHINEN TK305 Manual De Intrucciones

 Choose a level, vibration-free, non-slip surface for the installation location.
 Ensure sufficient space around the machine!
 Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects!
 Ensure a clean working environment.
 Only use perfect tools that are free of cracks and other defects (e.g. deformations).
 Remove setting tools from the machine before switching on.
 Keep the area around the machine free of obstacles (e.g. dust, chips, cut workpiece parts
etc.).
 Check the strength of the machine connections before each use.
 Never leave the running machine unattended. If necessary, stop the machine before leaving.
 The machine may only be operated, serviced or repaired by persons who are familiar with it
and who have been informed of the dangers arising in the course of this work.
 Ensure that unauthorised persons maintain an appropriate safety distance from the machine
and, in particular, keep children away from the machine.
 Wear suitable protective equipment (eye protection, dust mask, respiratory protection, ear
protection, gloves when handling tools) as well as close-fitting work protective clothing - never
wear loose clothing, ties, jewellery, etc. - danger of being drawn in!
 Hide long hair under hair protection.
 Do not remove any sections or other parts of the workpiece from the cutting area while the
machine is running!
 Always work with care and the necessary caution and never use excessive force.
 Do not overload the machine!
 Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
 Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
 Do not smoke in the immediate vicinity of the machine (fire hazard)!
 Only use suitable extension cords.
 Always shut down the machine before carrying out any conversion, adjustment, measuring,
cleaning, maintenance or repair work and always disconnect it from the power supply for
maintenance or repair work. Before starting any work on the machine, wait until all tools or
machine parts have come to a complete standstill and secure the machine against
unintentional restarting.

14.4 Electrical Safety

 A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from
heat, oil, sharp edges or moving parts.
 Proper plugs and sockets reduce the risk of electric shock.
 Water entry into machine increases the risk of electric shock. Do not expose machine to rain or
moisture.
 The machine may only be used in humid environments if the power source is protected by a
residual current circuit breaker.
 Do not use the machine if it cannot be switched on and off with the ON/OFF switch.
 Avoid contact of the body with grounded surfaces such as pipes, radiators, ovens and
refrigerators. There is an increased risk of electric shock if the body is earthed.

14.5 Special Safety Instructions for Woodworking machines

 During operation of the machine wood dust is generated. Therefore, connect the machine to a
suitable dust collection system for dust and chips during installation!
 Always switch on the dust collection system before you start machining the workpiece!
 Never remove sections or other parts of the workpiece from the cutting area while the machine
is running.
 When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must
comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-
3:2013;
 Excessive noise can cause hearing damage and temporary or permanent hearing loss. Wear
hearing protection certified to health and safety regulations to limit noise exposure.
 Replace cracked and deformed saw blades immediately, they cannot be repaired.
 Use clean and sharpened saw blades, which are less sensitive to malfunctions and easier to
guide.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
SAFETY
31
TK 305