Intended Use Of Clipping Machine Favorita Hybrid/Fav5 Hybrid; Operating Principle Of Clipping Machine Favorita Hybrid/Fav5 Hybrid; Preparation And Setup; Working With The Clipping Machines Favorita Hybrid/Fav5 Hybrid And The Adapter With Power Supply - B.Braun Aesculap Favorita Hybrid GT200 Instrucciones De Manejo

Aesculap Suhl GmbH
Clipping machine Favorita Hybrid/FAV5 Hybrid
2.3 Intended use of clipping machine
Favorita Hybrid/FAV5 Hybrid
Note
The device is intended exclusively for cutting animal
hair.
The clipping machine Favorita Hybrid/FAV5 Hybrid is
used for shearing small animals.
The clipping machine Favorita Hybrid/FAV5 Hybrid is
used with a shearing head to be selected according to
the respective application.
2.4 Operating principle of clipping
machine Favorita Hybrid/FAV5
Hybrid
The clipping machine FavoritaHybrid/FAV5 Hybrid is
switched on and off by sliding the On/Off switch up or
down, respectively.
3.

Preparation and setup

Non-compliance with these rules will result in com-
plete exclusion of liability on the part of Aesculap.
Always observe the following guidelines when set-
ting up and operating the product:
– national regulations for installation and opera-
tion,
– national regulations on fire and explosion protec-
tion.
– operating advisories according to IEC-/VDE regu-
lations.
Fire and explosion hazard!
Do not operate the product in
explosion-hazard areas.
DANGER
4
Malfunction of, or damage to the
product caused by improper setup!
Do not expose the product to
direct sunlight or moisture.
CAUTION
Do not cover the ventilation
slots of the product.
Connect the product to the
specified voltage of 100 V to
240 V/50 Hz to 60 Hz.
Ensure that the mains power
socket used for supplying the
product is freely accessible.
4. Working with the clipping
machines Favorita Hybrid/
FAV5 Hybrid and the adapter
with power supply

4.1 System set-up

4.1.1 Connecting the accessories

Combinations of accessories that are not mentioned in
the present instructions for use may only be employed
if they are specifically intended for the respective
application, and if they do not compromise the perfor-
mance and safety characteristics of the products.