Installing The Single Fan Hood - Dacor DHDU990I/DA Serie Instrucciones Para Instalación

Installation

Installing the single fan hood

1. Place the template in the ceiling considering the
instructions for ceiling support structures.
NOTE
Always consider the front of hood when placing the
template on the ceiling. It will define the control's
location.
2. Mark with a pencil the hole locations for screws and
duct in the ceiling. Remove the template.
3. Fix one duct cover enxtension on each of both sides
of one of the horizontal supports with 4 - 4.2 x 8 mm
screws using the Torx 20 adapter. That will be the
upper horizontal support.
C
B
A. Upper horizontal support
B. Duct cover extension
C. 4 - 4.2 x 8 mm screws
14 ENGLISH
4. Fix the upper horizontal support to the ceiling with
5. Install the 10" (25.4 cm) round transition over the
6. Fix lower vertical supports over the lower horizontal
A
C
4 - 5 x 45 mm screws. Use 8 x 40 mm anchors if
necessary.
transition adapter and place it over the vent opening
on the hood assembly as pictured below.
A
E
D
B
C
support with 16 - 4.2 x 8 mm screws.
A
A. Lower horizontal support
B. 16 - 4.2 x 8 mm screws
A. 10" round transition
B. Transition adapter
C. Hood assembly
D. 4 - 3.5 x 9.5 mm screws
E. 4 - 4.2 x 8 mm screws
B