aflamo AV-WM36IMP Manual Del Propietário página 18

Troubleshooting
DISCONNECTED THE APPLIANCE COMPLETELY AND LET COOL PRIOR TO ANY SERVICE.
ONLY A QUALIFIED SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
Problem
1. Fireplace turns off
and will not turn on.
2. Flame is not moving.
.
3. Flame is not visible.
4.Log set and/or is not
glowing.
5. Remote control
does not work.
6. Fireplace will not
come on when
switch is flipped to
ON.
WARNING
!
Possible Cause
1. Fireplace has overheated
and safety devise has caused
thermal switch to disconnect
or home circuit breaker has
opened.
1. Loose wiring.
2. Flame motor defective.
3.Flame rod out of place
1. Wiring is loose.
1.Wiring is loose.
2.Ember is in off mode
1. Low batteries.
2. Not aiming control correctly.
3. Defective remote control and
/or sensor.
1. Fireplace is not plugged in to
an electrical outlet.
2. Control failure.
3. Breaker tripped.
www.aflamo.com
Solution
1. Reset switch by turning main
power switch off and waiting 10
minutes then turning it back on
or reset circuit breaker.
1. Inspect wiring for loose con-
nections.
2. Call a qualified service techni-
cian to replace flame motor.
3."Flame Rod" out of place due to
rough transit/handling
product. This issue
corrected as simple as removing
the glass, flipping the fireplace
upside down, removing a set of
screws that are holding
bottom frame plate and placing
the flame rod back into place.
1. Disconnect from power source
and inspect wiring for loose
connections and repair or
replace if necessary.
2.Push the flame button to high
1.Disconnect from power source
and inspect wiring
connections and repair or replace
if necessary.
2.Push the ember button is high
1. Replace batteries in
remote control.
2. Aim control at sensor located
directly behind glass screen in
center of unit just above logs.
3. Replace remote control and/or
sensor.
1. Check plug.
2. Call a qualified service techni-
cian.
3. Reset breaker.
of the
can be
the
for loose
18