BIG ASS FANS HAIKU R Guia De Instalacion página 16

UNIVERSAL MOUNT INSTALLATION
8. Install mounting ball
Do not over-tighten the mounting ball screw.
Slide mounting ball over downrod (Fig. 8.1).
Insert 6 mm steel pin into hole at top of downrod, and then slide the mounting ball
upward, seating the steel pin in the inner slots (Fig. 8.2).
Insert wedge into mounting ball and secure with screw (Fig. 8.3). Tighten screw enough
to prevent movement between the mounting ball and downrod, but do not over-
tighten. Make sure rubber plug at top of downrod is still in place.
Fig. 8.1 Fig. 8.1 Fig. 8.1 Fig. 8.1 Fig. 8.1 Fig. 8.1 Fig. 8.1 Fig. 8.1 Fig. 8.1 Fig. 8.1 Fig. 8.1
Mounting
Ball
Downrod
14
Fig. 8.3
4 mm Screw
Wedge
Fig. 8.2 Fig. 8.2 Fig. 8.2 Fig. 8.2 Fig. 8.2 Fig. 8.2 Fig. 8.2 Fig. 8.2 Fig. 8.2 Fig. 8.2 Fig. 8.2
6 mm Steel Pin