BIG ASS FANS HAIKU R Guia De Instalacion página 34

LOW PROFILE MOUNT INSTALLATION
8. Secure mounting brackets
Raise fan to mounting plate. Insert one rubber bumper between the mounting plate and
the loosely installed mounting bracket. Secure the other bumper with the remaining
mounting bracket and 6 mm nylock nuts (Fig. 8). Tighten all four nuts with a wrench
until snug.
Fig. 8
Mounting Bracket
6 mm Nylock Nut
9. Install wiring cover and screw caps
Raise wiring cover, allowing about a 1/8" (3 mm) gap at ceiling. Align mounting slots with
screw holes on downtube and secure wiring cover with the wiring cover screws (Fig. 9).
Slide wiring cover trim up downtube, aligning the inside tabs with the slots on the
bottom of the wiring cover. Twist trim clockwise to secure in place (Fig. 9).
Insert the two downtube screw caps that match the color of your fan into the screw
holes at the bottom of the downtube (Fig. 9).
Fig. 9
Wiring Cover
5/16" Screw
Wiring Cover Trim
Downtube Screw Cap
32