Mark And Cut Vent Opening; Drill Electrical Opening; Prepare Range Hood Vents; Attach Vent Damper Or Transition - Samsung NK30B3000US/AA Guía De Instrucciones Para Instalación

Installation Instructions
To wire through wall:
1. Mark a line distance (A) from the right of the centerline on the
underside of the cabinet. Mark the point on this line that is
from the underside of the cabinet. Drill a
through the rear wall at this point.

Mark and Cut Vent Opening

For a non-vented (recirculating) installation: skip "Mark and Cut Vent
Opening" step.
For 7" (17.8 cm) Round Vent System (Roof Venting)
To make a circular vent opening on the underside of the cabinet top:
1. Mark a centerline on the underside of the top of cabinet.
2. Mark a line 5" (12.8 cm) from the back wall on the underside of the top
of cabinet.
3. Use a compass or a circle template to draw a circle with a diameter of
7½" (19 cm).
4. Use saber or keyhole saw to cut the circular vent opening. Repeat
steps 1-3 for the underside of the top of the cabinet.
Centerline
C abinet cutouts
*5"
(12.8 cm )

Drill Electrical Opening

1. Using a 1¼" (3 cm) drill bit, drill the hole in the dot marked previously
at the electrical strain relief.
⁄ " (2.2 cm)
7
8
⁄ " (2.2 cm) diameter hole (B)
7
8
B
7⁄8"
(2.2 cm)
A
A. 8 2/5" (21.3cm)
*From wall, not cabinet frame

Prepare Range Hood Vents

C
B
A
Install Strain Relief
1. Install a UL listed/CSA approved ½" (13 mm) strain relief (A).
For non-vented (Recirculating) Installations
Remove the (2) T10 Torx® screws and remove the top, front rectangular
vent cover (E). Go to "Electrical Connection" step.
7" (17.8 cm) Round Vent Mounting Plate
1. Using (2) short Phillips head screws, install the 7" (17.8 cm) round
vent mounting plate (A) over the vent knockouts removed in previ ous
step. Position the wide flange (B) to the front. .
A
E
D
B
English 9