Hayward Pool Rx LT Manual Del Usuario página 4

GB
• •
• WARNING –
Disconnect the equipment from the mains supply before any intervention.
• WARNING –
All electrical connections must be carried out by a qualified approved electrician in
accordance with the standards currently in force in the country of installation.
F NF C 15-100
D DIN VDE 0100-702
A ÖVE 8001-4-702
E UNE 20460-7-702 1993, REBT ITC-BT-31 2002
IRL IS HD 384-7-702
I CEI 64-8/7
LUX 384-7.702 S2
NL NEN 1010-7-702
P RSIUEE
• WARNING –
Check that the device is plugged into a power outlet that is protected against short-
circuits. The device must also be powered via an isolating transformer or a residual current device
(RCD) with a nominal operating residual current not exceeding 30 mA.
• WARNING –
Ensure that children cannot play with the device. Keep your hands and any foreign
object away from openings and moving parts.
• WARNING –
Check that the supply voltage required by the product corresponds to the voltage
of the distribution network and that the power supply cables are suitable for the product power
supply.
• WARNING –
Chemicals can cause internal and external burns. To avoid death, serious injury
and/or damage to equipment, wear personal protective equipment (gloves, goggles, mask, etc.) when
servicing or maintaining this device. This device must be installed in an adequately ventilated place.
• WARNING –
To reduce the risk of electric shock, do not use an extension cable to connect the
device to the mains. Use a wall socket.
• WARNING –
Carefully read the instructions that appear in this manual and on the device. Failure
to comply with the instructions can cause injuries. This document must be given to every pool user,
who should keep it in a safe place.
• WARNING –
The appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if
they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
• WARNING –
Use only original Hayward
• WARNING –
If the power supply cable is damaged, it must be replaced by the manufacturer, the
after-sales service or similarly qualified persons to avoid danger
• WARNING –
The device must not be used if the power cord is damaged. An electric shock
could occur. A damaged power cord must be replaced by the after-sales service or similarly qualified
persons to avoid danger.
WARNING: Electrical hazard.
Failure to comply with these instructions can result in
serious injuries or death.
THE EQUIPMENT IS INTENDED TO BE USED ONLY IN
SWIMMING POOLS
GB BS7671:1992
EW SIST HD 384-7-702.S2
H MSZ 2364-702:1994 / MSZ 10-533 1/1990
M MSA HD 384-7-702.S2
PL TS IEC 60364-7-702
CZ CSN 33 2000 7-702
SK STN 33 2000-7-702
SLO SIST HD 384-7-702.S2
TR TS IEC 60364-7-702
parts.
®
4